Battery Guard 2000 100A

If the available battery voltage remains below 12.1v or 24.1v uniformly for 2 minutes, the Battery Guard 2000 100A ECU provides an output that can drive a buzzer and activate a dash mounted reset switch which will be flashing.

If the voltage remains below 12.1v or 24.1v uniformly for a full four minutes, the batteries will be automatically isolated, to guarantee starting power. At this stage there will be no power at the ignition switch, the vehicle operator must press the flashing reset switch and then start the engine within the four minute timer period.

100A Battery Guard also offers the vehicle operator the ability to manually isolate the batteries via the Battery Guard reset switch.

200A Battery Guard also available.

Automatic low voltage battery isolator
Guarantees starting power – vehicle will start first time, every time
System test on start
Provides a means to manually isolate the battery
Ignition/Alternator protected – unit overridden when vehicle engine running
Fully waterproof Electronic Control Unit (ECU)
Delphi Packard IP67 waterproof connectors
Constantly monitors available battery power when the engine is not running
Manual override switch to enable vehicle starting
Optional speech module that will announce “driver warning low battery, please start your engine”
Approved by Paccar, Iveco, Scania, Dennis & MAN
Easy & quick to install
Available in 12v and 24v

Nominal Voltage: 12/24 VDC
Operating Temperature: -40°C to +85°C
Protection Class: IP 67
Approvals: ‘e’ Approval EMC 95/54/EC


Nominal operating current	12v	24v
Actuation current	3.0 amps	1.2 amps
Minimum actuation current	9 volts	18 volts
Maximum continuous carry	100 amps	100 amps
Maximum (30 seconds) carry current	500 amps	500 amps
Ambient temperature range	-40° to 85°C	-40° to 85°C
Normal input voltage range	10-16 volts	20-32 volts
Contact life at full load	min 10,000 cycles	min 10,000 cycles
Standby current	< than 1 milliamp	< than 1 milliamp
Short term over voltage protection to	+24 volts	+36 volts
Reverse voltage protection to	-800 volts	-800 volts
Positive voltage protection to	+150 volts	+150 volts